Table of Contents
Advertisement
"Connect using", select "COM1". Select "OK". A new dialog box will open named
"Com1 Properties". Setup the Port Settings as follows:
Bits per second:
Data Bits:
Parity:
Stop Bits:
Flow control:
Select "Apply". Then select "OK". This will take you into the "6300-M4
Hyperterminal" window.
2.
Select "File". Select "Properties". A new dialog box "6300-M4 Properties" appears.
Select the "Settings" tab. In the "Emulation" menu select "ANSI". Select "OK".
Now you are back in the "6300-M4 Hyperterminal" window. Select "File", select
"Save". Close this window. A warning appears, select "Yes". Hyperterminal is now
setup.
3.
To verify that the 6300-M4 file is setup in Hyperterminal, select "All Programs" from
the desktop, select "Accessories", select "Communications", select "Hyperterminal".
The "6300-M4" icon should appear. If it does not appear then you will need to
repeat steps 1 and 2 above.
4.4 DOWNLOADING PROFILES
1.
Connect the one-to-one RS232 cable to the RS232 port on the 6300-M4. You will need
to remove the access panel for this. Connect the other end of this cable to the COM1
port on your PC.
2.
Turn on the 6300-M4 and select Function 5, Set Profiles. The following screen
appears.
Stay in this screen until all profiles you would like to download have been
downloaded.
3.
Start the 6300-M4 file in Hyperterminal. On the task bar select "Transfer". Then
select "Send Text file". The dialog box will open that allows you to select the .txt file
9600
8
None
1
None
PROFILE SETUP
Please stay in this screen and download
One or more profiles through the RS232
interface. On completion press "GO".
39
Advertisement
Table of Contents
