Laversab 6300-M4 User Manual page 22

Parameter 6. Climb "Actual" value:
measured at the Static output, displayed in the current units. In the sample screen shown
below, the current rate of change of pressure at the Static output is 3500 feet/min.. This value
is updated every 0.25 seconds.
Units:
Actual:
Target:
Parameter 7. Pitot "Target" value:
achieve on the Pitot output. In the sample screen below, the 6300-M4 has been commanded to
achieve a pressure of 20.0 knots on the Pitot output. The Pitot "Target" value is meaningful
only when the Pitot output is in the "Control" mode. This is explained later in this section.
How to change the Pitot "Target" value is explained in section 3.2.2.
Units:
Actual:
Target:
Parameter 8. Static "Target" value:
achieve on the Static output. In the sample screen below, the 6300-M4 has been commanded
to achieve a pressure of 0 Feet on the Static output. The Static "Target" value is meaningful
only when the Static output is in the "Control" mode. This is explained later in this section.
How to change the Static "Target" value is explained in section 3.2.2.
Units:
Actual:
Target:
Parameter 9. Climb "Target" value:
achieve as the rate of change of pressure (climb/dive) on the Static output. In the sample
This is the current rate of change of pressure
knots
M 101.2
20.0
This is the value that you command the 6300-M4 to
knots
M 101.2
20.0
This is the value that you command the 6300-M4 to
knots
M 101.2
20.0
This is the value that you command the 6300-M4 to
15
Feet/min Feet
3500 1005
3000
Feet/min Feet
3500 1005
3000
Feet/min Feet
3500 1005
3000
M
0
M
0
M
0