Laversab 6300-M4 User Manual page 21

The two values (1005 and 0) that appear below it are in these units.
Units:
Actual:
Target:
Parameter 3. Climb Units: Unit of measurement for displaying the rate of change of the
Static output, or Climb. Normally, the climb unit used is 'Feet/min' for displaying rate of
change of altitude. These units cannot be independently chosen. Whatever the unit selected
for the Static output, the climb unit is the per minute rate of that selected Static unit. If the
Static unit selected is 'inHg' then the climb unit will be 'inHg/min'. The currently selected
climb unit is shown on the first line of the display (as shown below). The two values (3500
and 3000) that appear below it are in these units.
Units:
Actual:
Target:
Parameter 4. Pitot "Actual" value:
output, displayed in the current units. In the sample screen shown below, the current
pressure at the Pitot output is 101.2 knots. This value is updated every 0.25 seconds.
Units:
Actual:
Target:
Parameter 5. Static "Actual" value:
output, displayed in the current units. In the sample screen shown below, the current
pressure at the Static output is 1005 Feet. This value is updated every 0.25 seconds.
Units:
Actual:
Target:
knots
M 101.2
20.0
knots
M 101.2
20.0
This is the current pressure measured at the Pitot
knots
M 101.2
20.0
This is the current pressure measured at the Static
knots
M 101.2
20.0
14
Feet/min Feet
3500 1005
3000
Feet/min Feet
3500 1005
3000
Feet/min Feet
3500 1005
3000
Feet/min Feet
3500 1005
3000
M
0
M
0
M
0
M
0