Table of Contents
Advertisement
flashing. This indicates that the current profile point is ready for execution and awaiting the
"GO" key to be pressed. When the "GO" key is pressed, the 6300-M4 will execute the profile
point, i.e. it will change to Control mode and move towards the desired targets.
Units:
Actual:
Target:
ENTER PROFILE NUMBER :
Once the targets have been achieved, you can move to the next profile point by pressing
ENTER. Then, the parameter values in point 2 of profile # 2 will be displayed, the profile
number will change to "2.2" and will again flash, awaiting the "GO" key.
If you want only to view the profile without executing it, then DO NOT press the "GO" key.
Simply press the "ENTER" key to go to the next point in the profile. Each time you press the
"ENTER" key, the next profile point will be displayed. When you press the "ENTER" key
after the last point in the profile, the Main screen will revert back to its original setting prior to
invoking Function 4.
At any time, to exit out of the profile viewing or execution function, press CANCEL and the
screen will revert back to the last executed point.
3.5.5 FUNCTION 5: SETUP PROFILES
This function is used to load profiles into the 6300-M4 from a PC. A full explanation of how to
load profiles into the 6300-M4 is provided in Section 4.. The following screen will come up
when Function 5 is selected.
Once the profiles have been loaded, press GO to exit this function.
3.5.6 FUNCTION 6: HEIGHT CORRECTION
This function allows the user to enter the difference in height between the 6300-M4 and
Ground level. This value should normally be 0 unless the 6300-M4 is elevated to a height of
more than 3 feet above ground level. A value of between 0 and 50 feet can be entered. The
screen appears as shown below.
knots
C
101.2
100.0
PROFILE SETUP
Please stay in this screen and download
One or more profiles through the RS232
interface. On completion press "GO".
Feet/min
3500
5000
2.1 CJ1-RVSM
33
Feet
1005
C
1000
Advertisement
Table of Contents
