Table of Contents
Advertisement
The "6600" icon should appear. If it does not appear then you will need to repeat
steps 1 and 2 above.
4.4 DOWNLOADING PROFILES
1.
Connect the one-to-one RS232 cable to the RS232 port on the 6600. You will need to
remove the access panel for this. Connect the other end of this cable to the COM1
port on your PC.
2.
Turn on the 6600 and select Function 5, Set Profiles. The following screen appears.
Stay in this screen until all profiles you would like to download have been
downloaded.
3.
Start the 6600 file in Hyperterminal. On the task bar select "Transfer". Then select
"Send Text file". The dialog box will open that allows you to select the .txt file you
want to transfer. Open this file. You will see the profile being downloaded as it is
echoed back from the 6600.
4.
After the profile has completed downloading, the last section should say "PASS". If
it does not then the profile did not download correctly. If no characters are echoed
when you open the .txt file to download then you probably have a communication
problem.
5.
If you see "garbage" on the first line of the profile as it downloads then you should
redo the download. This could happen on some systems on the very first profile you
download during a session in Hyperterminal.
6.
To download more profiles in the same session simply repeat step 3 from the point
you select "Transfer". After all profiles you wish to download have been transferred,
press GO on the 6600. Check that the profile loaded properly by selecting Function 4
on the 6600 and entering the profile number starting at step 1 (i.e. "18.1" to check
profile 18). Step through the profile using only ENTER and check if the points match
what you have setup on the PC as your profile.
PROFILE SETUP
Please stay in this screen and download
One or more profiles through the RS232
interface. On completion press "GO".
52
Advertisement
Table of Contents
