Table of Contents
Advertisement
Properties". Setup the Port Settings as follows:
Bits per second:
Data Bits:
Parity:
Stop Bits:
Flow control:
Select "Apply". Then select "OK". This will take you into the "6300 Hyperterminal"
window.
2.
Select "File". Select "Properties". A new dialog box "6300 Properties" appears.
Select the "Settings" tab. In the "Emulation" menu select "ANSI". Select "OK".
Now you are back in the "6300 Hyperterminal" window. Select "File", select "Save".
Close this window. A warning appears, select "Yes". Hyperterminal is now setup.
3.
To verify that the 6300 file is setup in Hyperterminal, select "All Programs" from the
desktop, select "Accessories", select "Communications", select "Hyperterminal".
The "6300" icon should appear. If it does not appear then you will need to repeat
steps 1 and 2 above.
4.4 DOWNLOADING PROFILES
1.
Connect the one-to-one RS232 cable to the RS232 port on the 6300. You will need to
remove the access panel for this. Connect the other end of this cable to the COM1
port on your PC.
2.
Turn on the 6300 and select Function 5, Set Profiles. The following screen appears.
Stay in this screen until all profiles you would like to download have been
downloaded.
3.
Start the 6300 file in Hyperterminal. On the task bar select "Transfer". Then select
"Send Text file". The dialog box will open that allows you to select the .txt file you
want to transfer. Open this file. You will see the profile being downloaded as it is
echoed back from the 6300.
9600
8
None
1
None
PROFILE SETUP
Please stay in this screen and download
One or more profiles through the RS232
interface. On completion press "GO".
45
Hide quick links:
Advertisement
Table of Contents
