Function 5: Setup Profiles; Function 6: Height Correction; Function 7: Set Ground - Laversab 6300 User Manual

If you want only to view the profile without executing it, then DO NOT press the "GO" key.
Simply press the "ENTER" key to go to the next point in the profile. Each time you press the
"ENTER" key, the next profile point will be displayed. When you press the "ENTER" key
after the last point in the profile, the Main screen will revert back to its original setting prior to
invoking Function 4.
At any time, to exit out of the profile viewing or execution function, press CANCEL and the
screen will revert back to the last executed point.

3.5.5 FUNCTION 5: SETUP PROFILES

This function is used to load profiles into the 6300 from a PC. A full explanation of how to
load profiles into the 6300 is provided in Section 4.. The following screen will come up when
Function 5 is selected.
Once the profiles have been loaded, press GO to exit this function.

3.5.6 FUNCTION 6: HEIGHT CORRECTION

This function allows the user to enter the difference in height between the 6300 and Ground
level. This value should normally be 0 unless the 6300 is elevated to a height of more than 3
feet above ground level. A value of between 0 and 50 feet can be entered. The screen appears
as shown below.
Current Height Correction = 0 feet
New Height Correction
Enter new height (0-50) or press CANCEL

3.5.7 FUNCTION 7: SET GROUND

The "Set Ground" function is used to indicate to the 6300 the ambient "Ground" pressure.
Before connecting the 6300 to the aircraft, just after the Self Test has been performed, it is
PROFILE SETUP
Please stay in this screen and download
One or more profiles through the RS232
interface. On completion press "GO".
= feet
38