BRAYER BR1114 Instruction Manual page 9

light up, when the buttons (18, 19, 20) illumination
lights up, it means preheating is completed.
• Switch the water supply on by pressing the button
(19) « », the pump will switch on for 30 seconds
and hot water will be poured into the cup. After
switching the pump off, pour the water out from the
cup.Preheating is over.
MAKING ESPRESSO
ATTENTION! When making coffee do not leave the
operating coffee maker unattended, as it is necessary to
watch the cup being filled with ready coffee!
AFTER PREHEATING:
• Make sure that the steam supply is closed. To do this
turn the knob (9) « » clockwise until bumping
«•».
• Remove the filter holder (5) by turning the handle (4)
to the left «INSERT» and remove the filter holder (5).
• Put ground coffee in the small or large filter (6),
slightly tamp the ground coffee with the back side of
the measuring spoon (16).
• Install the filter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler «INSERT», after that turn the filter holder
handle (4) to the right until bumping «LOCK».
• Wait until the buttons (18, 19, 20) illumination lights
up, the coffee maker is ready for making coffee.
• If you use a small filter (6), switch the water supply
on by pressing the button (18) «
cup of coffee, the pump will switch on and work for 15
seconds, the pump operation time of 15 seconds is set
by default.
• To prepare two cups of coffee, use a large filter (6) and
press the button (19) «
and work for 30 seconds, the pump operation time of 30
seconds is set by default.
Note: - watch the cup filling with the ready coffee, if you
need t switch the water supply off, press again the button
(18) «
• Switch the espresso machine off by pressing the on/
off button (17) «
illumination will go out.
• Wait until the coffee maker cools down and remove
the filter holder (5) by turning the handle (4) to the left
«INSERT». Remove the ground coffee remnants and
wash the filter (6).
• For easy removing of the coffee remnants use the
retainer on the handle (4) to prevent the filter (6) from
falling off the holder (5).
• Notes:
- the cups should be preliminary heated up, when
water heats up in the boiler, put the cups on the tray
(8).
- if you need to promptly remove the filter holder (5),
you have to reduce the pressure in the boiler, switch
the coffee maker off by pressing the on/off button
(17) «
(11) and slightly open the steam supply by turning
the knob (9) «
» to prepare one
», the pump will switch on
» or the button (19) « ».
», the buttons (17, 18, 19, 20)
», place a suitable cup under the tip
» counterclockwise. After the
EN 9