BRAYER BR1114 Instruction Manual page 8

8 EN
• Wait until the buttons (18, 19, 20) illumination lights up,
then switch the water supply on by pressing the button
(19) « », the pump will switch on for 30 seconds,
drain the water from the cup and again press the button
(19) « » to switch the water supply on again. After
switching the pump off, drain the water from the cup.
• Repeat this procedure several times, the boiler will be
clean after that.
• To switch the espresso machine off, press the on/
off button (17) « », the buttons (17, 18, 19, 20)
illumination will go out.
ATTENTION!
• Do not remove the filter holder (5) during espresso
machine operation.
• Do not remove the filter holder (5) immediately after
preparing coffee as there is redundant water and steam
pressure inside the filter (5), let the coffee maker cool
down completely.
• To remove the filter holder (5) turn the handle (4) to the
left «INSERT» and remove the filter holder (5).
AUTO SWITCH OFF FUNCTION
• If no actions were performed during 25 minutes
after switching on, the coffee maker will switch off
automatically.
HOW TO MAKE A GOOD ESPRESSO
• Use ground coffee for espresso coffee makers.
• Slightly tamp the ground coffee in the filter (6), you
can do it with the back side of the measuring spoon
(17).
• Coffee strength depends on the quality and grinding
degree of coffee beans. If coffee is pouring out too
long, this means the coffee powder is too fine or it is
tamped too strongly.
PREHEATING
• To make a cup of hot espresso, it is recommended to
preliminary heat up the coffee filter (6) and the filter
holder (5).
• Open the lid (14) and fill the tank (15) with water, or
remove the tank (15) and fill it with water, then install
the tank (15) back to its place.
• Insert one of the coffee filters (6) into the holder (5).
Notes:
- use the small filter (6) to make one cup of coffee
and press one cup button (18) «
- use the big filter (6) to make two cups of coffee
and press two cups button (19) «
• Install the filter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler «INSERT », after that turn the filter holder
handle (4) to the right until bumping «LOCK».
• Place a suitable cup on the grid (2).
• Insert the power plug into the mains socket.
• Switch the coffee maker on by pressing the on/off
button (17) « », the button (17) illumination will
»;
».