BRAYER BR1114 Instruction Manual page 7

• Transport the coffee maker in the original package.
• Keep the unit out of reach of children and disabled
• persons.
COFFEE MAKER IS INTENDED FOR HOUSEHOLD
USE ONLY, DO NOT USE THE COFFEE MAKER FOR
COMMERCIAL OR LABORATORY PURPOSES.
BEFORE USING THE COFFEE MAKER
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Unpack the coffee maker and remove all the
packaging materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the coffee maker for damages, in case of
damage do not plug it into the mains.
• Make sure that the specifications of power supply
voltage specified on the lower panel of the unit
correspond to the specifications of your mains.
• Wipe the coffee maker body (12) surface with a
clean, slightly damp cloth to remove dust, wipe the
coffee maker body (12) dry.
• Make sure that the steam supply is closed. To do this
turn the knob (9) « » clockwise until bumping
«•».
• Before using the espresso machine for the first time,
wash all removable parts (1, 2, 5, 6, 15, 16) with
warm water and neutral detergent, rinse and dry
them.
• Remove the water tank (15), fill it with cold water up
to the MAX mark and install it back to its place.
Notes:
- to fill the water tank (15) with water you can open
the lid (14) and pour water into the tank (15).
- to carry the water tank (15), take it by the handle
(13).
• Insert any coffee filter (6) into the holder (5) (do not
add ground coffee into the filter).
• Install the filter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler «INSERT», after that turn the filter holder
handle (4) to the right until bumping «LOCK».
• Place a suitable cup on the grid (2).
• Insert the power plug into the mains socket.
• Switch the coffee maker on by pressing the on/off
button (17) « », the button (17) illumination will
light up, when the buttons (18, 19, 20) illumination
will light up, this means that preheating is completed.
Notes:
- the first switching on of the pump may be
accompanied by an uncharacteristic sound, this
is a normal. After filling the boiler with water, the
sound of the pump will return to normal.
EN 7