BRAYER BR1114 Instruction Manual page 6

6 EN
power cord hang from the edge of the table and
make sure it does not touch hot surfaces or sharp
edges of furniture.
• Do not place the coffee maker on hot surfaces.
• Do not touch the power cord and the power plug with
wet hands.
• Use only the coffee maker parts and accessories
supplied with the unit.
• Before switching the coffee maker on, make sure that
all removable parts are installed properly.
• Ensure that the water level in the water tank is not
below the minimal mark.
• Do not switch the coffee maker on if the water tank
is empty.
• To avoid getting burns by hot steam be careful when
frothing milk or warming the ready drinks.
• The filter holder surface, the cappuccinator pipe and
the cappuccinator tip can get rather hot. Be cautious
and careful when in contact with hot surfaces.
• Do not remove the filter holder during coffee maker
operation.
• Let the unit cool down completely before cleaning
and removing the accessories.
• Unplug the coffee maker before cleaning or when you
are not using it. When unplugging the coffee maker
hold only the power cord plug and carefully remove it
from the mains socket, do not pull the power cord —
this can lead to damage of the power cord or the
socket or cause short circuit.
• For children safety reasons do not leave polyethylene
bags, used as a packaging, unattended.
ATTENTION!
Do not allow children to play with polyethylene bags
or packaging film. Danger of suffocation!
• The coffee maker is not intended for usage by
children.
• Do not leave children unattended to prevent using
the unit as a toy.
• Do not allow children to touch the unit and the power
cord during the coffee maker operation.
• Place the unit out of reach of children during the
operation and cooling down.
• This unit is not intended for usage by physically or
mentally disabled persons (including children) or by
persons lacking experience or knowledge if they are
not under supervision of a person who is responsible
for their safety or if they are not instructed by this
person on the usage of the unit.
• From time to time check the power cord and the
power plug integrity.
• If the power cord is damaged, it should be replaced
by the manufacturer, a maintenance service or
similar qualified personnel to avoid danger.
• Do not repair the unit by yourself. Do not
disassemble the unit by yourself, if any malfunction
is detected, and after it was dropped, unplug the unit
and apply to the service center.