The mapping also creates the possibility of changing this modified printer into
a normal one by plugging in the special connector from the Protected Printer
example on page 51.
Figure 51. Panel Selected Label Printing Mapping Table
When port switching is enabled, the serial port is the only port with which the
printer can talk to itself. To make the printer talk to itself, a special serial
connector is required that connects the transmit data output to the receive
data input. Any form of handshaking for data transmission control should be
disabled. This can be accomplished by connecting pin 4 (RTS) to pin 5 (CTS)
and to connect pin 6 (DSR) to pin 8 (CD) and to pin 20 (DTR). Thus, when
one of the three front panel buttons is pressed, the printer receives a
message through the serial port sent out of that serial port by the same
printer.
The serial connector is displayed in Figure 52.
Figure 52. Panel Selected Label Printing Serial Connector
Panel Selected Label Printing
1
14
2
15
3
16
4
17
5
18
6
19
7
20
8
21
9
22
10
23
11
24
12
25
13
53