Using Reports - Printronix P5000 Series User Manual

Chapter 2
Defining Reports

Using Reports

To make sure the correct report is transmitted to the front panel LCD, add the
following entry to the mapping table.
Figure 34. Defining Entries in the GPIO Manager
Once the report has been defined and the Send Report action has been
selected, the parameter block allows you to specify what is to be done with
this report.
The Source drop down menu allows you to select a report previously created.
The Destination options tell the system where to transmit the report. The
Seconds field sets the time the report will be visible (applicable only to the
front panel LCD). See Figure 34.
Once the Action parameters are set, update the Forms Counter Tracking
entry to achieve the following mapping table (Figure 35).
Figure 35. Results of a Mapping Table with Specific Parameters
36