Printronix P5000 Series User Manual page 15

•
Power Save Mode Active
This event signals the moment when the printer enters Power Save
Mode.
•
Power Save Mode Cleared
Opposite of the Power Save Mode Active, this mode signals the moment
the printer becomes active.
•
Start Data Processing
This event signals the start of the processing of received data. This is not
the same as the Start Printing event.
•
End Data Processing
This event signals the end of the data processing cycle. This is not the
same as the end printing event.
•
Buffers Empty
This event takes place as soon as the print buffers are emptied.
•
Label Pending
This event generates when the printer is in Local mode (i.e., the print
engine is temporarily stopped) and all incoming data has been processed.
•
Start Printing
This event happens when the printer starts printing. The printer starts
printing when all data processing is done, there is actual data to print, and
the printer is no longer in local mode. The event will not happen on "paper
moves without print."
•
Start Paper Move
This event is only available in the Impact Printer mode of the GPIO
Manager. It indicates the beginning of the paper motion.
•
Label Printed
This event occurs when a number of labels stored in the printer have
finished printing. If the labels print as a single job without any wait time,
the event will be a short pulse. If the printer is placed in local mode and
the labels are printed using the print next label action, the event will
happen once for each label.
•
Label Present
In label peel off applications, this event happens when the label present
sensor detects a label in position (ready for application). It may be used to
signal the availability of a label to an applicator system.
•
Label Taken
This event is generated when the label is taken from its ready to apply
position. It can be used to tell the host that a new label can be printed.
•
Job Printed
This even is generated if everything in the buffer has been printed.
Events and Actions
15