Table of Contents
Advertisement
Remote Control Fires - For Diagrams refer to section 2
5.1
Removing the RC Burner Assembly
5.1.1
Prepare work area (lay down dust sheets etc.)
5.1.2
Remove the fascia and ash pan cover and put them in a safe location.
Isolate the gas supply. Remove the glass panel, unscrewing the top
and side retaining brackets, see page 10 & 11 of this manual for
information. Carefully lift clear the glass panel. Remove the coals, front
ceramic from the rail and fuel-bed base matrix. Remove all of the loose
coals and front ceramic rail. Unscrew the two pozi-drive fixing screws
which secure the burner heat shield and remove it from the fire.
5.1.3
Unscrew the 4 off burner retaining screws on the side brackets, the
burner should then be lifted out of the firebox.
5.1.4
To refit the burner assembly, re-assemble in reverse order and carry out
a gas tightness test. Refit the burner heat shield then refit the coals
referring to section 3 for the correct coal layout. Refit the glass panel
and glass panel retaining trims. Refit the fascia and ashpan cover.
5.2
Removing the Remote Gas Valve from the fire
5.2.1
Prepare work area (lay down dust sheets etc.)
5.2.2
Remove the burner assembly as described in section 5.1.
5.2.3
Remove the thermocouple wires from the valve, remove the
main pipe, inlet pipe and pilot pipe from the valve.
5.2.4
Remove the valve retaining screws and lift clear. Re-assemble in
reverse order and carry out a gas tightness test. Re-fit coals / pebbles
as shown in section 3. Refit the fascia and ashpan cover.
43
Advertisement
Table of Contents
