Blowing Out Inside Of Unit; Coolant Maintenance - Miller Dynasty 210 Owner's Manual

12-4. Blowing Out Inside of Unit

12-5. Coolant Maintenance

1
GTAW Or Where
Application
HF* Is Used
Low Conductivity Coolant No. 043810**; Distilled Or Deionized Water
°
OK Above 32
Coolant
*HF: High Frequency Current
**Coolant 043810, a 50/50 solution, protects to -37
NOTICE − Use of any coolant other than that listed in the table voids the warranty on any parts that come in contact with the coolant (pump,
radiator, etc.).
OM-270536 Page 66
.
A complete Parts List is available at www.MillerWelds.com
°
F (0 C)
° °
F (-38 C) and resist algae growth.
!
Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
805497-A
!
Disconnect input power be-
fore maintaining.
1 Coolant Filter
Unscrew housing to clean filter.
Changing coolant: Drain coolant by
tipping unit to the front, or use suc-
tion pump. Fill with clean water and
run for 10 minutes. Drain and refill
with coolant.
.
If replacing hoses, use hoses
compatible with ethylene gly-
col, such as Buna-N, Neo-
prene, or Hypalon. Oxy-acety-
lene hoses are not compatible
with any product containing
ethylene glycol.
Tools Needed:
T25 Torx
805502-A