Section 7 − Maintenance; Routine Maintenance; Blowing Out Inside Of Unit - Miller Axcess 300 Owner's Manual

7-1. Routine Maintenance

n = Check
* To be done by Factory Authorized Service Agent
Every
l Unreadable Labels
3
Months
nl Cords
Every
6
Months
~ Drive Rolls

7-2. Blowing Out Inside Of Unit

OM-216 967 Page 30
SECTION 7 − MAINTENANCE
Z = Change ~ = Clean
~ Weld Terminals
nl Gun Cables
OR
~ Inside Unit
!
Disconnect power
before maintaining.
l = Replace
l Damaged Gas Hose nl Weld Cables
.
Maintain more often
during severe conditions.
Reference
!
Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
Ref. 803 667-A