Accessing Control Panel Menu - Miller Dynasty 210 Owner's Manual

10-2. Accessing Control Panel Menu

2
OM-270536 Page 52
.
A complete Parts List is available at www.MillerWelds.com
3
4
150A
Process Selection:
TIG HF Impulse − is a non-contact arc starting method for TIG welding (see Section 17-1).
TIG Lift-Arc − Is a contact arc starting method for TIG welding (see Section 17-1).
Stick − Select for DC Stick (SMAW) welding. Electrode polarity is determined by the welding
cable connections.
Trigger Mode Selection: (See Section for 11-4 for additional trigger function options).
[RMT] [STD]
Typical setting for a remote foot or hand control. RMT STD requires a maintained contact clos-
ure to enable weld output. Amperage can be controlled with a remote potentiometer, or it can
be set at the control panel.
[RMT] 2T [HOLD] (TIG Only)
Remote control required. Allows the operator to weld without holding the trigger closed. To
start the weld, operator presses and releases trigger. To stop the weld, the operator again
presses and releases the trigger. In this mode, only the output contactor is controlled by the
remote control. Amperage must be set on the control panel. (see Section 11-4).
[OUT] [ON]
Output on. (Stick and TIG Lift only)
!
Weld output terminals are energized at all times when displays read [OUT] [ON].
No remote control or trigger required. Amperage can be controlled at the control panel or with
a remote potentiometer. Blue output on LED illuminates to indicate output is on.
1 Amperage Button
2 Parameter Display
3 Setting Display
4 Encoder
Rotate Encoder to adjust paramet-
er setting.
1
The Amperage Control controls the
welding amperage output, and lim-
its the maximum output of a remote
amperage device.
150A
247216-A