Table of Contents
Advertisement
D. Software Installation
1
Dynasty 210 DX Shown
Notes
.
A complete Parts List is available at www.MillerWelds.com
.
2
Software updates may reset
machine back to default val-
ues.
Card Requirements:
Full size memory card required.
1
Memory Card Port
2
Indicator LED
Insert card containing new soft-
ware into port while machine is on,
(but not while welding). Inserting
card while welding will interrupt the
welding process.
LED indicator blinks green when
machine is reading from or writing
to the card, and the meter displays
go blank. The update time may vary
up to three minutes. Do Not re-
move card while LED is blinking
green.
After successfully reading from or
writing to the card, the LED
switches from blinking to continu-
ous green, and the meters illumi-
nate. The machine is now ready for
use.
Troubleshooting:
Indicator LED is blinking red: Error
updating software, or software is
not compatible. Try removing and
inserting card.
Indicator LED is continuous red:
Cannot read card. Card might be
bad.
805496-A
OM-270536 Page 31
Advertisement
Table of Contents
Troubleshooting
