Table of Contents
Advertisement
GENERAL SAFETY REGULATIONS
THIS SAFETY CODE HAS BEEN COMPILED IN YOUR INTEREST. Strict adherence to
these rules will reduce the risks of injury both to yourself and to others;
Personnel working with this machine must adhere strictly to all statutory safety regulations as well
as the specific rules listed below. Failure to do so may result in personal inyury and damage to
the machine;
-
DO NOT attempt to move, install, set-up or operate this machine until you have read and
fully understood this Manual. If doubt persists, ask your supervisor;
-
never leave tools, parts or other loose material on or in the machine;
-
Before switching the equipment the equipment on, make sure that the model plate data
conforms to that of the electrical and water distribution network;
-
remember that even with the mains isolator in the "OFF" position, the incoming cables are
still live;
-
BEFORE starting machine o cycle, after any maintenance or repair work, make sure all
protective are correctly installed;
-
be vigilant at all times, remember that your safety and that of your fellow workers depend on
you;
-
when moving or lifting the machine, care must be taken to comply with all the relevant
regulations governing such operations;
-
installation should be carried out by qualified personnel according to the manufacturer's
instructions.
-
this equipment should be destined to the use which it has been conceived for. Any other
application should be considered improper and consequently dangerous;
-
the equipment should only be used by personnel trained for its use;
SPECIAL SAFETY REGULATIONS
-
adjustement and repairs must be carried out only by personnel qualified. Repair carried out
by unskilled personnel may be dangerous;
-
perfect washing-up results as far as hygiene concerns and a correct operation of the
washing machine can be assured only in case the instructions reported in the present
handbook are carefully followed;
-
the machine must be only used by authorized personnel which must comply with sanitary
measures;
-
do not leave the machine in environment with temperatures inferior to 0°C;
-
the machine protection degree is IP55 for Control board and IP33 for machine, therefore it
should not be washed with direct high pressure jets of water;
7
Advertisement
Table of Contents
