Water Connections - Water Draining - lamber LINEAR 30 Instruction Manual

STEAM FEEDING *
As far as steam feeding is concerned,
connect to the machine fittings indicated
in the installation drawings. In order to
make the equipment independent from
the general steam distribution network, it
is necessary to use gate and gas on/off
valves (see draw 2 and 3).
This type of feeding should be supplied at
a pressure ranging from 1 bar (100°C) to
2 bar (121°C).
The steam used should be absolutely
saturated and dry.
.
STEAM EXHAUST *
The condensed steam exhaust shall have
an appropriate slope toward the recovery
installation or a blow-by pump, in order to
guarantee an autonomous scavenging of
the condensed steam.
N.B.: for possible maintenance operations,
it is advisable to arrange a gate valve
parallel with the discharge so that it is
possible to deviate condensation towards a
runoff pit.
*
for steam machines only
VAPOURS SUCTION
For machines equipped with splashguard
with collar or heat recovery, carry out the
necessary connection as showed in
figure 4.
In any case it is necessary to provide a
way to extract steam through a hood or
a similar system.
29