Table of Contents
Advertisement
Attention: before setting the clutch check
the belt tension by ruling the screws of the
turnbuckle in entrance.The right position
must allow to lift the belt 10 centimeters
over its support in the central part of it.
This adjustment should be repeated 6
months after the first installation.
STEAM CONDENSER
As regards the machines provided with
"STEAM
CONDENSER"
device,
pay
attention to the following:
The adjustment of the device is carried out
by means of the regulator valve (COCK
"V") placed inside the machine base plate
and marked with its special label.
The Manufacturer should rule this cock
while testing the machine.
Never touch this cock without a specific
reason.
This valve rules the water flow in the
vapour condensing battery.
If the machine needed a more precise
adjustment, under regular conditions adjust
the valve until no more vapour comes out
of the "vapour condensing" cap.
Generally it is sufficient to slightly open the
valve.
ATTENTION! An excessive opening can
cause the cooling of the tank.
31
Advertisement
Table of Contents
