Operation - Quick BTR Series Installation And User Manual

6 - Operation

6.0 - Dip-Switch for option selection
SELECTION FUNCTION
1
Reserved (always keep off)
It indicates to the CAN control station that the thruster is in the bow (OFF)
2
It indicates to the CAN control station that the thruster is in the stern (ON)
3 Reserved (always keep off)
4 Reserved (always keep off)
FACTORY SETTING: 1 = OFF, 2 = OFF, 3 = OFF, 4 = OFF
6.1 - Actuator current rotary selector
The ten selectable steps (from 0 to 9) allow you to set a percentage referring to the "maximum current/load" allowed for the
actuator in use (see table).
ROTARY SELECTOR
POSITION
0
1
2
3
4
5
6
7
8
9
If a setting other than the factory setting is required, proceed as follows:
1) With the board not powered, place the arrow of the rotary selector in the desired position.
2) After powering the board again, the percentage corresponding to the selected position will be automatically set.
If the maximum current/load limit is too low compared to the real needs of use, the thermal cut-outs of the actuator may be
tripped during retractable thruster closing and opening with error 1 and 7 flashing.
MAXIMUM CURRENT/
LOAD %
28%
36%
44%
52%
60%
68%
76%
84%
92%
100%
QUICK BTR Series INSTALLATION AND USER'S MANUAL - REV 001C
BTR Series
DIP-SWITCH
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
EN
19