Tripp Lite B006-VU4-1 Owner's Manual page 19

10. Firmware Upgrade Utility
Upgrade Successful
After the upgrade has completed, a screen will appear to inform you that the procedure was successful:
Click Finish to close the Firmware Upgrade Utility.
After a successful completion, the B006-VU4-1 exits Firmware Upgrade Mode and resets itself.
Upgrade Failed
If the Upgrade Succeeded screen does not appear, the upgrade failed to complete successfully, in which case you should
do the following:
1. Press and hold the Port 1 selection pushbutton. While you are holding the pushbutton, connect the B006-VU4-1 to the
computer using the USB cable of the custom cable set to enter Firmware Upgrade Mode. The front panel LEDs will
flash to indicate that Firmware Upgrade Mode is in effect.
2. Run the upgrade again. See Starting the Upgrade for details.
19