Polycom V500 Release Note page 8

Release Notes
V500 and VSX systems, version 8.5
remotemonenable
Gets the state of remote room and call monitoring.
remotemonenable get
rs232monitor
Sets or gets the state of RS-232 serial port monitoring. When RS-232
monitoring is enabled, you can view all communication through the serial port
as output to Telnet port 23.
rs232monitor get
rs232monitor <on|off>
secondarycallchoice
Sets or gets the secondary call type for placing calls.
secondarycallchoice <get|isdn|ip|sip|none>
telnetmonitor
Sets or gets the state of Telnet session monitoring. When Telnet monitoring is
enabled, you can view all communication to and from the Telnet port 24
session as output to Telnet port 23.
telnetmonitor get
telnetmonitor <on|off>
unregisterall
Alias for the all unregister command.
useroompassword
Sets or gets the Use Room Password for Remote Access setting.
useroompassword get
useroompassword <no|yes>
v35broadcastmode
Sets or gets the V.35 broadcast mode. This command is only applicable if you
have a V.35 network interface connected to your system.
v35broadcastmode <get|on|off>
videocallorder
Sets the video call order of the specified protocol to the specified slot.
videocallorder <isdn|h323|sip> <1|2|3>
voicecallorder
Sets the voice call order of the specified protocol to the specified slot.
voicecallorder <pots|voice|vtx> <1|2|3>
8