Polycom V500 Release Note page 32

Release Notes
V500 and VSX systems, version 8.5
Feature Limitation
User Interface During the out-of-box setup, if you select SIP instead of
H.323, the system will restart before configuration is
complete. After the restart, the system will return to the LAN
Properties page, allowing you to complete system
configuration.
A VSX 8000 system set up for single-monitor VGA displays a
black border around the user interface screens.
If you set Line Input to Audio Mixer and check Enable
Polycom StereoSurround, a message is displayed that
Polycom microphones will be disabled. The microphones are
actually disabled in this case, even though the System Status
screen shows them as active.
Incoming POTS calls are not recorded in the Recent Calls
list. Outgoing POTS calls are listed correctly.
Systems that are configured to use a UPnP NAT and are
registered with a gatekeeper do not display the E.164
extension on the Place a Call screen.
When you disable the Polycom microphones through Admin
Settings > Audio > Audio Settings, the microphone status
does not indicate the disabled status on the Diagnostics >
System screen, showing the normal green arrow.
V.35 In H.320 calls from a V.35 VSX system with encryption
enabled, the far-site system does not recover from a
momentary loss of data.
V.35 profiles are not localized. They appear in English.
When you place a V.35 Direct Connect call from a VSX 7000
to a ViewStation EX running release 6.0.1 software, the call
may not connect. When the call fails to connect, the VSX
system's user interface displays the dialing screen and the
ViewStation EX system's user interface does not appear to
be receiving a call. Disconnecting the call and reconnecting
should clear the problem.
VGA Resolution The VGA resolution setting is only effective when the
attached monitor is not capable of DDC (Plug-N-Play). If the
monitor is capable of DDC, then the best resolution for the
incoming VGA source is selected.
32