DoorKing 1835 Owner's Manual page 65

6.1.7 Display DKS Data over IP Phone Number or System ID Number
This will allow you to see the DKS Data over IP issued 10-digit phone number or system ID number that has been programmed
into the telephone entry system.
JKL JKL MNO MNO
1. Press
5 6
The LCD display will show the 10-digit phone number or system ID number.
Note: The display will show C's (C C C C C C C C C C) if a phone number or system ID has NOT been programmed.
6.1.8 Test Connection to DKS Data over IP
This will allow you to test the connection to the DKS Data over IP or display problems that may have occurred.
ABC ABC WXYZ WXYZ
1. Press
2 9
The LCD display will show one of the following and the entry system will BEEP accordingly:
System is Registered - (beep)
- System is registered and communication to DKS Data over IP is good.
Check Registration
- Make sure your registration is current and this system is set to DKS Data over IP on the
registration screen. Also, be sure that the system phone number or ID number and the
master code are set the same on DKS Data over IP and the entry system.
Program 10 Digit ID
- There is not a valid 10-digit ID in the entry system memory. (see section 3.2.10)
Turn DKS Data over IP On
- There is a valid 10-digit ID, but DKS Data over IP is turned OFF. (see section 6.1.9 below)
No DKS Data over IP Contact
- Communication to DKS Data over IP could not be made.
Note: If there is pending data to be transfered when this test is performed, the data transfer will occur.
6.1.9 Turn DKS Data over IP OFF or ON
Use the following sequence to turn DKS Data over IP OFF or ON.
If you are going to use the RS232 connection for any other RS232 functions other than DKS Data over IP (e.g., connecting a PC
directly to the phone entry system via the RS232 terminal), the DKS Data over IP must be turned OFF.
The DKS Data over IP must be ON to use the entry system with DKS Data over IP. Note: When section 3.2.10 (DKS Data over
IP Phone Number or System ID Number is programmed, the DKS Data over IP is automatically turned ON.
If there is NOT a valid 10 digit system phone number or system ID number in memory, the system will emit three (3) short
beeps. Beep ... Beep ... Beep
JKL JKL JKL JKL
1. Press
5 5
OPER OPER
2. Press (beep) to turn OFF, OR
0
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0
N Y
1835-065-D-5-17
and enter your four-digit MASTER CODE
and enter your four-digit MASTER CODE
one beep
- (beep-beep)
- (beep-beep-beep)
- (beep-beep-beep-beep)
- (beep-beep-beep-beep-beep)
and enter your four-digit MASTER CODE
SP SP
1
h l h
? ? ? ?
? ? ?
two beeps
three beeps
four beeps
? ? ?
(beep) to turn ON.
i DKS D
?
(beep).
?
(beep).
five beeps
?
(beep).
IP d l bl
61