3.6 Programming Device Codes
Device codes MUST be five (5) digits in length and are typically used for a remote Wiegand card reader or transmitter devices.
Each device code that you enter must be assigned to a directory code that you select (that was programmed in section 3.5.2).
Up to 25 device codes can be entered under a single directory code, up to a maximum of 8,000 total device codes for the entry
system. The maximum number that can be programmed in is 65405. You cannot duplicate device codes.
3.6.1 Programming Five-Digit Device Codes
This program sequence enters device (card, transmitter, digital) codes into the system memory.
PQRS
PQRS
OPER
OPER
1. Press
7 7
0 0
2. Enter the existing directory code (section 3.5.2 or 3.5.4) that the device code will be assigned to (1, 2, 3 or 4 digits, section
3.5.1), then press
3. Choose and enter a five-digit device code, then press
4. Repeat steps 2 and 3 to enter additional device codes. (You cannot duplicate device codes)
OPER
OPER
5. Press
together to end this programming sequence (beeeeeep).
0 0
3.6.2 Deleting Device Codes
This program sequence deletes individual device codes.
PQRS
PQRS
SP
SP
1. Press
7 7
1 1
2. Enter the existing directory code (section 3.5.2 or 3.5.4) that the desired device code has been assigned to (1, 2, 3 or 4
digits, section 3.5.1), then press
3. Enter the desired five-digit device code, then press
4. Repeat steps 2 and 3 to delete additional desired device codes.
OPER
OPER
5. Press
together to end this programming sequence (beeeeeep).
0 0
3.6.3 Enabling Facility Codes
This program sequence allows you to use (enable) or not use (disable) facility codes.
PQRS
PQRS
ABC
ABC
1. Press
7 7
2 2
OPER
OPER
2. Enter
(beep) to disable facility codes, or enter
0 0
OPER
OPER
3. Press
together to end this programming sequence (beeeeeep).
0 0
3.6.4 Programming Facility Codes
This program sequence enters device facility codes into the system memory. Up to 10 facility codes (reference numbers 0
through 9) may be programmed. Valid facility codes are 000 – 255.
PQRS
PQRS
DEF
DEF
1. Press
7 7
3 3
2. Enter the single-digit first facility code reference number (0 – 9), then press
3. Enter the three-digit facility code, then press
4. Repeat steps 2 and 3 to enter additional facility codes.
OPER
OPER
5. Press
together to end this programming sequence (beeeeeep).
0 0
1835-065-D-5-17
and enter your four-digit MASTER CODE
(beep).
and enter your four-digit MASTER CODE
(beep).
and enter your four-digit MASTER CODE
and enter your four-digit MASTER CODE
? ?
? ?
? ?
(beep). (Maximum number that can be programmed in is 65405)
? ?
? ?
? ?
(beep).
? ?
? ?
? ?
SP
SP
(beep) to enable facility codes
1 1
? ?
? ?
? ?
(beep).
? ?
(beep).
? ?
(beep).
? ?
(beep).
? ?
(beep).
(beep).
47