Receiving Faxes; Setting Receive Mode - Epson WorkForce Pro WF-3730 Series User Manual

User's Guide
❏ Inside of Image: Sends a fax with header information approximately 7 mm lower than the top of the
scanned image. The header may overlap with the image, however, the fax received by the recipient will not
be split into two documents.
4. Tap the Fax Header box, and then select the header you want to use.
5. Tap one of the Additional Information options as necessary.
6. Tap OK to apply the settings.
Related Information
"Fax Settings" on page 129
&
Sending Different Size Documents Using ADF (ADF Continuous Scan)
If you place different sized originals in the ADF, all of the originals are sent at the largest size among them. You can
send them in their original sizes by sorting and placing them by size, or placing them one by one.
Before placing originals, make the following setting.
Tap Fax on the home screen, tap the Fax Settings tab, and then tap the ADF Continuous Scan box to set this to
On. Follow the on-screen instructions to place originals.
The printer stores the scanned documents, and sends as one document.
Note:
If you leave the printer untouched for 20 seconds after prompted to set the next originals, the printer stops storing and starts
sending the document.
Related Information
"Fax Settings" on page 129
&
Sending a Fax from a Computer
You can send faxes from the computer by using the FAX Utility and PC-FAX driver. See the help of FAX Utility and
PC-FAX driver for the operating instructions.
Related Information
"PC-FAX Driver (Fax Driver)" on page 166
&
"FAX Utility" on page 166
&

Receiving Faxes

Setting Receive Mode

You can make a Receive Mode using Fax Setting Wizard. When making fax setting at the first time, we
recommend you to use the Fax Setting Wizard. If you want to change only the Receive Mode, follow the
instruction below.
Faxing
120