Making Basic Fax Settings - Epson WorkForce Pro WF-3730 Series User Manual

User's Guide
Note:
When sharing a single phone line, make sure you connect the phone device to the EXT. port of the printer. If you split
the line to connect the phone device and the printer separately, the phone and the printer do not work correctly.
3. Tap Fax on the home screen.
4. Pick up the handset.
The connection is established when
Related Information
"Making Settings for a PBX Phone System" on page 114
&

Making Basic Fax Settings

First make basic fax settings such as Receive Mode using the Fax Setting Wizard, and then configure the other
settings as necessary.
The Fax Setting Wizard is automatically displayed when the printer is turned on for the first time. Once you have
made the settings, you do not need to make them again unless the connection environment is changed.
Making Basic Fax Settings Using the Fax Setting Wizard
Make basic settings by following the on-screen instructions.
1. Connect the printer to the phone line.
Note:
Because an automatic fax connection check runs at the end of the wizard, make sure you connect the printer to the
phone line before starting the wizard.
2. Tap Settings on the home screen.
3. Tap General Settings > Fax Settings > Fax Setting Wizard.
4. On the Fax Setting Wizard screen, tap Proceed.
The wizard begins.
Faxing
x
(Send) is enabled as the following screen.
112