Download Print this page

Connecting Power - Extron electronics TLP Pro 1225TG, TLP Pro 1525TG Setup Manual

Advertisement

G
Audio output (see
figure 5
devices.
H
MENU button — Activates the setup menu (see
I
RESET button — Pressing the reset button allows the unit to be reset in any of four different modes (see
Brief Summary
on page 6). For more information, see the TLP Pro 1225, 1525, and 1725 Series User Guide).
J
RESET LED — Provides feedback about the reset status when the user presses the reset button.

Connecting Power

ATTENTION:
Do not power on the touchpanels until you have read the Attention notification in the "Rear Panel Features" section of the
TLP Pro 1225, 1525, and 1725 Series User Guide.
Ne branchez pas les écrans tactiles avant d'avoir lu la mise en garde dans la section « Rear Panel Features » du
TLP Pro 1225, 1525, and 1725 Series User Guide.
The TLP Pro 1725TG ships with the Extron PI 140 power injector included. For the TLP Pro 1225TG and TLP Pro 1525TG, the power
injector must be purchased separately. Figure 6 shows the PI 140. Your power injector may look different.
Connect a straight-through Ethernet cable from the power injector to a switch or router. This cable carries network information
1.
from the switch or router to the power supply input.
Connect a second straight-through cable from the power injector to the
2.
XTP/PoE/LAN connector of the touchpanel (see
This cable carries the network information and 48 VDC from the power injector
to the touchpanel.
Connect the IEC power cord to a convenient 100 VAC to 240 VAC, 50-60 Hz
3.
power source.
Alternatively, use an Ethernet cable to connect the XTP/LAN/PoE+ port of the
interface to a PoE+ switch or connect the touchpanel directly to an XTP model that
is capable of remotely powering a touchpanel (see the
on page 4) — One 3.5 mm line level audio output for use with headphones or assistive listening
Setup Menu
figure 5
,
note
on page 4).
on page 6).
F
, on page 4).
Extron PI 140
Figure 6.
Product Category
Reset Modes: A
100-240V~50/60 Hz
1.1A MAX
INPUT
OUTPUT
LAN
POWERED TLP
To Network or
To a TLP Pro
XTP Device
touchpanel
Connecting the Power Injector
5

Advertisement

loading

This manual is also suitable for:

Tlp pro 1725tg