Advertisement
G
Audio output (see
figure 5
H
Reset LED — Provides feedback about the reset status when the user presses the reset button.
I
Menu button — Activates the setup menu (see
J
Reset button — Pressing the reset button allows the unit to be reset in any of four different modes (see
page 5). For more information, see the TLP Pro 1225 and TLP Pro 1525 Series User Guide).
Connecting Power
ATTENTION:
Do not power on the touchpanels until you have read the Attention notification in the "Rear Panel Features" section of
•
the TLP Pro 1225 and TLP Pro 1525 Series User Guide.
Ne branchez pas les écrans tactiles avant d'avoir lu la mise en garde dans la section « Rear Panel Features » du
•
TLP Pro 1225 and TLP Pro 1525 Series User Guide.
The power injector must be purchased separately. Figure 6 shows the Extron PI 140. Your power injector may look different.
Connect a straight-through Ethernet cable from the power injector to a switch or router. This cable carries network information
1.
from the switch or router to the power supply input.
Connect a second straight-through cable from the power injector to the
2.
XTP/PoE/LAN connector of the touchpanel (see
This cable carries the network information and 48 VDC from the power injector
to the touchpanel.
Connect the IEC power cord to a convenient 100 VAC to 240 VAC, 50-60 Hz
3.
power source.
Alternatively, use an Ethernet cable to connect the XTP/LAN/PoE+ port of the
interface to a PoE+ switch or connect the touchpanel directly to an XTP model that
is capable of remotely powering a touchpanel (see the
on page 4) — For use with headphones or assistive listening devices.
Setup Menu
figure 5
,
note
on page 4).
on page 6).
F
, on page 4).
Extron PI 140
Figure 6.
Product Category
Reset Modes
100-240V~50/60 Hz
1.1A MAX
INPUT
OUTPUT
LAN
POWERED TLP
To Network or
To a TLP Pro
touchpanel
XTP Device
Connecting the Power Injector
on
5
Advertisement
