11.2 ADJUSTING THE KICK PLATE
12 INSTALLER CHECKLIST
Your installer must have completed and
checked the following:
• The dishwasher is square and level.
• The dishwasher is fastened securely to
the cabinetry.
• The dishwasher door opens and closes
freely. The dishwasher door must close
without hitting any cabinetry or counter
top.
• The inlet water supply is turned on and
checked for leaks.
• The drain hose has been connected and
checked for leaks. There must be no
kinks or obstructions in the drain hose.
•
Check whether the bottom
of the door (A) hits the
kitchen cabinet base (B) .
•
If the door hits the cabinet
base cut the necessary
section out of the base (B).
•
Apply silicone or sealant to
the cut edge of the kitchen
cabinet base or paint so it
does not absorb moisture.
• The drain hose must be installed with a
28" (710mm) high drain loop for drain
hook-ups without any air removed.
• If the dishwasher drain is hooked up to a
garbage disposal, the drain hopper plug
must be removed.
• The spray arms are free and rotate freely.
• The rinse cycle has been run.
• The water level will be below the
filter screen after the end of the wash
program. It is normal to find some water
in the drain filter area.
24
USA