Viking Range RVCH336 Installation Manual
Hide thumbs Also See for RVCH336:

Advertisement

Quick Links

Installation
3 Series
Hoods
RVCH330
RVCH336

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RVCH336 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Viking Range RVCH336

  • Page 1 Installation 3 Series Hoods RVCH330 RVCH336...
  • Page 2: Table Of Contents

    Table of Contents Warnings & Important Information_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 RVCH Classic Chimney Wall Hoods w/Standard Ventilator Dimensions &...
  • Page 3 IMPORTANT– Please Read and Follow! NOTE: If installing hood with warming shelf panel, W A R N I N G install warming shelf panel first. TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, IMPORTANT – PLEASE READ AND FOLLOW OR INJURY TO PERSONS, OBSERVE THE •...
  • Page 4 IMPORTANT– Please Read and Follow! W A R N I N G W A R N I N G TO REDUCE THE RISK OF INJURY TO PERSONS TO REDUCE THE RISK OF FIRE, IN THE EVENT OF A RANGETOP GREASE FIRE, ELECTRICAL SHOCK, OR INJURY OBSERVE THE FOLLOWING.
  • Page 5: Rvch Classic Chimney Wall Hoods W/Standard Ventilator

    Dimensions & Specifications (RVCH Classic Chimney Wall Hoods w/Standard Ventilator) ” ( 4 0 ” ( 3 0 2 ” ( 5 . ( 3 0 ” ( 7 6 ” ( 3 0 ” ” A (Hood width) ( 6 1 30”W.
  • Page 6: Clearance Dimensions

    Clearance Dimensions (RVCH Classic Chimney Wall Hoods w/Standard Ventilator) ” m ” m ( 1 6 i n . ( 7 6 7 . 6 i n . ” m ” m ( 1 7 ( 8 3 5 . 3 ”...
  • Page 7: Interior Ventilator Dimensions

    Interior Ventilator Dimensions (RVCH Classic Chimney Wall Hoods w/Standard Ventilator) Top view 16” (40.6 cm) 4” 30”W. 14-15/16” (37.9 cm) (10.2 cm) 9-3/4” 36”W. 17-15/16” (45.6 cm) (24.8 cm) 120 V 7” (17.8 cm) dia. duct location 460 CFM Interior Ventilator Installation...
  • Page 8: Planning Information

    Planning Information Plan where the duct work will be located. Install 300 or 600 CFM Roof cap proper-sized duct work, roof, or wall cap for the type single blower interior-power of blower you are using. Adjust your measurements typical ductwork 7”...
  • Page 9: Installation (Rvch Classic Chimney Wall Hoods W/Standard Ventilator)

    Installation (RVCH Classic Chimney Wall Hoods w/Standard Ventilator) Check damper for unrestricted movement, Attach transition to damper. Seal with aluminum tape. adjust if necessary. W A R N I N G TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING •...
  • Page 10 CAUTION: If not using a duct cover, using CAUTION: Secure vent hood to wall using screws provided. screws provided make sure top mounting screws are Use additional mounting screws and wall anchors, if necessary. secured into soffit or cabinet frame. Use additional mounting screws, if necessary.
  • Page 11: Duct Cover (Rvch Classic Chimney Wall Hoods W/Standard Ventilator)

    Slide filter front over front lip. Push filter rear up, then slide back over rear lip. Duct Cover (RVCH Classic Chimney Wall Hoods w/Standard Ventilator) Measure distance from ceiling to canopy. Tape to avoid scratching. Place duct cover top inside duct cover base and lower until desired Slide duct cover in place and fasten from inside height is found.
  • Page 12: Installation (Rvch Classic Chimney Wall Hoods W/Recirculating Kit)

    Installation (RVCH Classic Chimney Wall Hoods w/Recirculating Kit) NOTE: If installing a duct cover with a recirculationg kit, the duct cover must be attached to the recirculating kit before installing on the hood. Remove damper and discard with transition. Turn recirculating unit upside down. Place vent hood upside down on recirculating unit.
  • Page 13 W A R N I N G TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING • Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
  • Page 14 Assemble brackets to mesh filters and insert Slide filter front over front lip. Push filter rear up, charcoal filters. then slide back over rear lip. Slide spacer front over front lip. Push spacer rear up, then Slide filter front over front lip. Push filter rear up, slide back over rear lip.
  • Page 15: Service & Registration

    Clearly describe the problem that you are having. If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range at 1-888-845-4641, or write to: VIKING RANGE, LLC...
  • Page 16 Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-845-4641 or visit our website at vikingrange.com F21205E EN (050120)

This manual is also suitable for:

Rvch3303 series

Table of Contents