Kodak CARESTREAM DRYVIEW 5850 User Manual page 37

Code
27604 Optics: Calibration Failed
27607 Optics: Calibration Failed
27611 Optics: Internal Hardware
Failure
27646 Optics: Internal Hardware
Failure
27650 Optics: Internal Hardware
Failure
27931 Optics: Internal Communications
Failure
28154 Processor: Internal
Communications Failure
28155 Processor: Internal
Communications Failure
28501 Processor: Internal Hardware
Failure
28509 Processor Warm-up Failure
28510 Processor: Internal Hardware
Failure
28551 Processor Heater Failure
28554 Processor Over Temperature
28931 Processor: Internal
Communications Failure
29154 Densitometer: Internal
Communications Failure
February 27, 2009
Table 3-5: Condition Codes (Cont'd)
Web Portal Message User Action
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
2G0733
Troubleshooting
3-11