Working With Quality Test Prints; Requesting A Test Print At The Imager; Requesting A Test Print At The Web Portal - Kodak CARESTREAM DRYVIEW 5850 User Manual

Working with Quality
Test Prints
Requesting a Test Print
at the Imager
Requesting a Test Print
at the Web Portal
February 27, 2009
The Imager can print an internally generated density test print with a
SMPTE pattern. Density test prints can be used as a quality assurance tool to
verify the uniformity of films printed by the Imager. The 5850 Laser Imager
provides additional test prints for mammography quality control.
You can request a test print at the Imager or from the Web Portal.
1. At the Imager, press the Setup button for approximately 5 seconds.
The Test Print menu displays.
2. Select the desired test print, and press the Enter button to initiate the
test print.
3. Select Cancel to exit from the Test Print menu.
1. Access the Web Portal (see
2. Select Diagnostics>Test Print.
3. For "Select Test," use the drop-down menu to select the desired test.
For example, for the SMPTE pattern, select Density Test.
4. Enter an optional label to be printed on the test film.
5. Enter the desired density (0.1 to 3.2).
6. Use the drop-down menu to select the film tray.
7. Select the number of copies to be printed.
8. Click Run.
2G0733
Using and Maintaining the Imager
"Accessing the Web Portal").
2-13