Kodak CARESTREAM DRYVIEW 5850 User Manual page 35

Code
21122 or xxxxx Supply: Internal
23122 Hardware Failure
21125 or xxxxx Supply: Internal
23125 Hardware Failure
21126 or Film Jam in Area 1: xxxxx
23126 Supply
21130 or xxxxx Supply: Internal
23130 Hardware Failure
21131 or xxxxx Supply: Internal
23131 Hardware Failure
21139 or xxxxx Supply: Unable to
23139 Identify Film Pack
21145 or xxxxx Supply: Unsupported
23145 Film Type
21146 or xxxxx Supply: Unsupported
23146 Film Size
February 27, 2009
Table 3-5: Condition Codes (Cont'd)
Web Portal Message User Action
1. Cover the film tray with the film saver. Remove the
tray from the Imager.
2. Take the film tray to a dark room and remove the
film saver. Verify that the film is lying flat. Replace
the film saver.
3. Re-insert the film tray and remove the film saver.
4. If this error repeats, try a new film pack.
5. If the error persists, call for service.
1. Cover the film tray with the film saver. Remove the
tray from the Imager.
2. Re-insert the film tray and remove the film saver.
3. If the error persists, call for service.
See "Film Jam - Code 2x126".
1. Cover the film tray with the film saver. Remove the
tray from the Imager.
2. Re-insert the film tray and remove the film saver.
3. If the error persists, call for service.
1. Cover the film tray with the film saver. Remove the
tray from the Imager.
2. Re-insert the film tray and remove the film saver.
3. If the error repeats, shut down the Imager, then start
the Imager.
4. If the error persists, call for service.
1. Try a different film pack.
2. If the error persists, call for service.
1. The Imager has not been configured to use this film
type.
2. Try a different film type or reconfigure the Imager.
3. If the error persists, call for service.
1. The Imager has not been configured to use this film
size.
2. Try a different film size or reconfigure the Imager.
3. If the error persists, call for service.
2G0733
Troubleshooting
3-9