Kodak CARESTREAM DRYVIEW 5850 User Manual page 30

Troubleshooting
Film Tray
State
Manual Mode • Attention LED on
• Status code: 21002 (upper),
23002 (lower)
• Unlock button LED on
• Cal button LED off
• Tray info area displays film
type, size, and count
No Film Tray • Unlock button LED on
• Cal button LED off
• Tray info area displays icon
for this state
Ready • Unlock button LED on
• Cal button LED off
• Tray info area displays film
type, size, and count
Requires • Attention LED on
Calibration • Status code: 21001 (upper),
23001 (lower)
• Unlock button LED on
• Cal button LED off
• Tray info area displays film
type, size, and count
Supply Open • Ready LED off
• Unlock button LED off
• Cal button LED off
• Tray info area blank
Unlock Pending • Ready LED off (or blinking if
active print)
• Cal LED off (or blinking if
active calibration)
• Unlock button LED blinking
• If the film tray requires a
cover, the status code is:
Status code: 21004 (upper),
23004 (lower)
3-4
Table 3-3: Film Tray Status Messages (Cont'd)
Local Panel
2G0733
Web Portal
Display
The film in this film tray does
not meet AIQC standards.
However, the user has selected
"Manual Mode," so it will be
used as if it is "Ready."
Invalid Film Tray There is a film tray in the film
supply but it does not contain a
liner/RF tag.
Normal Tray Info The film tray is ready for use.
Requires The film tray must be calibrated
Calibration before the Imager can print from
it.
No Film Tray There is no film tray inserted.
Both trays must be inserted in
order for the Imager to operate.
Unlock An "Unlock" has been requested
Requested but has not started because of
one of the following:
• films are still moving through
the Imager
• the film tray contains film but
has not been covered with a
film saver
Once the conditions for unlock
is met, film tray can be removed.
Description
February 27, 2009