Kodak CARESTREAM DRYVIEW 5850 User Manual page 36

Troubleshooting
Code
21624 or xxxxx Supply: Film Calibration
23624 Failure
21631 or xxxxx Supply: Film Calibration
23631 Failure - Dmin Outside Target
21632 or xxxxx Supply: Film Calibration
23632 Failure - Dmax Outside Target
25922 RF Tag: Internal Diagnostic
Failure
25931 RF Tag: Internal
Communications Failure
26325 Film Jam in Area 2
26326 Film Jam in Area 2 or 3
26543 Film Jam in Area 3
26544 Film Jam in Area 3
26931 Film Transport: Internal
Communications Failure
26933 Film Transport: Internal
Communications Failure
27123 Optics: Internal Hardware
Failure
27601 Optics: Calibration Failed
3-10
Table 3-5: Condition Codes (Cont'd)
Web Portal Message User Action
1. Try calibration again, or try a different film pack.
2. If the error repeats, shut down the Imager, then start
the Imager.
3. If the error persists, call for service.
1. The minimum density of the film is too high.
Calibration results for this film are outside the
normal range, but will still be used.
2. If you do not wish to use these calibration results,
perform a new calibration on this film or try
another film pack.
1. The maximum density of the film is lower than the
target density. Calibration results for this film are
outside the normal range, but will still be used.
2. If you do not wish to use these calibration results,
perform a new calibration on this film or try
another film pack.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
See "Film Jam - Code 26325".
See "Film Jam - Codes 26326 or
See "Film Jam - Codes 26326 or
See "Film Jam - Code 26544".
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
2G0733
26543".
26543".
February 27, 2009