Table of Contents
Advertisement
WARNING:
MAKE SURE THAT THE TRACTOR IS SHUT OFF AND THE RAKE CANNOT MOVE
BEFORE SERVICING THE FLEX-FRAME RAKE. MAINTENANCE AND REPAIR
SERVICE WORK TO BE PERFORMED BY A QUALIFIED SERVICE PERSON ONLY.
TROUBLE
Rake Will Not Open
Rake Will Not Close
Rake Wheels Will Not
Lower
Rake Will Not Latch
TROUBLESHOOTING
POSSIBLE CAUSE
Rake Locked In Transport
Pull Rope or Cable Broken
Hydraulic Couplers Not Coupled
To Tractor Properly
Tractor Hydraulics Do Not Have
Sufficient Pressure
Tractor Hydraulics Do Not Have
Sufficient Pressure
Rake Wheels Locked In Transport
Lift Pipe Binding
Hydraulic Hoses Mixed Up With
Rake Wheel Lift Hose
Tractor not on level ground
Hitch not adjusted properly
Not enough hydraulic power
-29-
POSSIBLE REMEDY
Remove Transport Locks And
Return To Storage Position
Replace Rope or Cable
Couple Hydraulic Hoses To Tractor
Tractor Should Have At Least 1500
PSI To Operate Rake
NOTE: Always Drive Forward Slowly
And Open Rake At The Same Time
Tractor Should Have At Least 1500
PSI To Operate Rake
NOTE: Always Drive Forward Slowly
And Open Rake At The Same Time
Remove Hair Pin From Adjuster,
Place In Storage Position
Check Lift Pipe Make Sure It Is Free
Moving
Sort Hoses Correctly And Re-couple
To Tractor
Move to level location
Adjust hitch so the latch bar is
centered in the auto-latch opening
when the rake is on level ground.
Move in reverse to help the rake
arms pull in
Advertisement
Table of Contents
