Safety Instructions; General - Eneo DOME-WB8 Quick Installation Manual

SAFETY INSTRUCTIONS

General

• Before switching on and operating the system, first read this safety advice and the operating instructions�
• Keep the operating instructions in a safe place for later use�
• Installation, commissioning and maintenance of the system may only be carried out by authorised individuals
and in accordance with the installation instructions - ensuring that all applicable standards and guidelines are
followed�
• Protect the devices from water penetration and humidity, since these can cause lasting damage�
• Should moisture nevertheless enter the system, under no circumstance switch on the devices under these
conditions, instead send them for examination to an authorised specialist workshop�
• The system must never be used outside of the technical specifications, since this can destroy it�
• The device must be protected from excesses of heat, dust, humidity and vibration�
• When separating the system from the voltage supply, only ever use the plug to pull out the cable� Never pull
directly on the cable itself�
• Lay the connecting cables carefully and check that they are not mechanically stressed, kinked or damaged and
that no humidity can penetrate into them�
• In the event of a malfunction, please inform your supplier�
• Maintenance and repairs may only be carried out by authorised specialist personnel�
• The system must be isolated from the power supply before opening the housing�
• The device may only be opened by qualified service personnel� Unauthorised access invalidates any warranty
claim�
• Connection cables should always be exchanged through Videor E� Hartig GmbH�
• Use only original spare parts and accessories from Videor E� Hartig GmbH�
• The housing should only be cleaned using a mild domestic cleaning agent� Never use solvents or petrol as these
can permanently damage the surface�
• During installation, it is essential to ensure that the seals provided are correctly installed and that they are not
displaced during installation� Damaged seals must not be installed and will invalidate any warranty�
• The installer is responsible for the maintenance of the enclosure as per the technical data, e�g� by sealing the
cable outlets with silicone�
• Wire end ferrules should be used when shortening the flexible connection cables�
• The devices may only be operated in the temperature range indicated in the data sheet and within the defined
air humidity range�
4