Table of Contents
Advertisement
Available languages
Available languages
www.videor.com
SAFETY INSTRUCTIONS
GENERAL SAFETY INSTRUCTIONS
Before switching on and operating the system, first read this safety advice and the operating instructions.
•
Keep the operating instructions in a safe place for later use.
•
Installation, commissioning and maintenance of the system may only be carried out by authorized
individuals and in accordance with the installation instructions - ensuring that all applicable standards
and guidelines are followed.
•
Protect the devices from water penetration and humidity, since these can cause lasting damage.
•
Should moisture nevertheless enter the system, under no circumstance switch on the devices under
these conditions, instead send them for examination to an authorized specialist workshop.
•
The system must never be used outside of the technical specifications, since this can destroy it.
•
The device must be protected from excesses of heat, dust, humidity and vibration.
•
When separating the system from the voltage supply, only ever use the plug to pull out the cable.
Never pull directly on the cable itself.
•
Lay the connecting cables carefully and check that they are not mechanically stressed, kinked or
damaged and that no humidity can penetrate into them.
•
In the event of a malfunction, please inform your supplier.
•
Maintenance and repairs may only be carried out by authorized specialist personnel.
•
The system must be isolated from the power supply before opening the housing.
•
The device may only be opened by qualified service personnel. Unauthorized access invalidates any
warranty claim.
•
Connection cables should always be exchanged through VIDEOR E. Hartig GmbH.
•
Use only original spare parts and accessories from VIDEOR E. Hartig GmbH.
•
The housing should only be cleaned using a mild domestic cleaning agent. Never use solvents or petrol
as these can permanently damage the surface.
•
During installation, it is essential to ensure that the seals provided are correctly installed and that they
are not displaced during installation. Damaged seals must not be installed and will invalidate any
warranty.
•
The installer is responsible for the maintenance of the enclosure as per the technical data, e.g. by
sealing the cable outlets with silicone.
•
Wire end ferrules should be used when shortening the flexible connection cables.
•
The devices may only be operated in the temperature range indicated in the data sheet and within the
defined air humidity range.
© Copyright
SOLVIDO
by VIDEOR E. Hartig GmbH
Januar 2024 | Technische Änderungen vorbehalten
3
Advertisement
Chapters
Table of Contents
