FLOWTECH Flowpress Mini Single Operation And Maintenance Manual page 19

4) Re-insert connector into the correct location on the control board and route
the cable to the back of the Flowpress Mini and secure with a cable tie to the retainer.
5.24 Fuses: The following fuse size should be used:
5.25 Supply cord replacement:
The supply cord and internal wiring within the terminal box are routed and secured
bolt
to ensure compliance with the electrical standard EN 60335-1. It is essential that
prior to any disturbance of this internal wiring, all cable routing and securing details
are carefully noted to ensure re-assembly to the same factory pattern is always
maintained.
If the supply cord is to be changed or is damaged, it must be replaced with a special cord assembly
available from Flowtech Water Solutions or one of their approved repairers.
On disassembly note the cord retention and routing system. Re-assemble to the same pattern.
For information on cable connection consult the wiring diagram.
flowpress
Model
All models
Mini Digital Pressurisation Unit
Fuse Size (AMPS)
5