Summary of Contents for FLOWTECH flowpac compact SE
Page 1
SE Pump Manual OPERATION AND MAINTENANCE MANUAL First Publication Date: 01/09/2020 Revision: Revision Date:...
Page 2
General Information These instructions are to assist in the installation of the flowpac compact SE Pump please follow them carefully. If, having read this Operation & Maintenance Manual, there is any doubt about any aspect of the installation please don't hesitate to contact our technical team.
Page 3
Water Solutions. This document is intended for ALL installers, operators, users and persons carrying out maintenance of this equipment and must be kept with the equipment, for the life of the equipment and made available to all persons at all times.
Safety Warnings & Precautions These instructions should be read and clearly understood before working on the system. Please read this manual carefully and all of the warning signs attached before installing or operating the equipment keep this manual handy for your reference. This equipment should be installed, adjusted and serviced by trained and qualified personnel.
Page 5
exclamat CAUTION! - It is strongly recommended that all electrical equipment conforms to National Electrical Codes and local regulations. Only qualified personnel should perform installation, alignment and maintenance. The manufacturer reserves the right to alter the technical data in order to make improvements or update information. exclamat CAUTION! - Failure to observe these rules will render the guarantee invalid.
If it is, immediately inform the person who delivered it. After extracting the motor pump from its packaging, make sure that it was not damaged during transportation. If it has been, inform Flowtech within 8 days from delivery. Check the motor-driven pump plate to ensure that the indicated characteristics are those requested by you.
the diameter of the pipe; its distance from the bottom of the reservoir should also be one and a half times its diameter. For suctions longer than 4 metres use an oversized pipe (1/4” wider at suction for improved efficiency). Installation a) Position the pump on a flat surface that is as close as possible to the water source.
Page 8
Submersible motor-driven pumps – In single phase versions, plug the unit into the socket. – For three phase versions (FIG. 5), check that the motor turns in a clockwise direction looking at the pump from the top, proceed as follows: with the motor-driven pump not yet secured to the system, connect the power cable to the terminal board and switch on briefly;...
Troubleshooting DISPLAYED FAULT CAUSE SOLUTION Float sticking Check that the float reaches the level ON Thermal protection activated It reactivates automatically (single phase (single phase) only) Incorrect electrical connection Check the terminal board and the electrical panel Automatic switch triggered or Reset the switch or replace the fuses and fuses blown verify the cause...
Page 10
Disposal When disposing of the pump, please comply rigorously with the regulations in force in your country, making sure that residues of the treated liquid are not left inside the pump. Most of our pumps do not contain hazardous polluting material. Specific cases are, however, indicated in the “DISPOSAL” chapter in PART 2. This symbol on the pump means that it cannot be disposed of with household waste.