Summary of Contents for FLOWTECH flowpac compact 1F.BD
Page 1
1F.BD Pump Manual OPERATION AND MAINTENANCE MANUAL First Publication Date: 01/09/2020 Revision: Revision Date:...
Page 2
General Information These instructions are to assist in the installation of the flowpac compact 1F.BD Pump please follow them carefully. If, having read this Operation & Maintenance Manual, there is any doubt about any aspect of the installation please don't hesitate to contact our technical team.
Page 3
Water Solutions. This document is intended for ALL installers, operators, users and persons carrying out maintenance of this equipment and must be kept with the equipment, for the life of the equipment and made available to all persons at all times.
Safety Warnings & Precautions These instructions should be read and clearly understood before working on the system. Please read this manual carefully and all of the warning signs attached before installing or operating the equipment keep this manual handy for your reference. This equipment should be installed, adjusted and serviced by trained and qualified personnel.
Page 5
exclamat CAUTION! - It is strongly recommended that all electrical equipment conforms to National Electrical Codes and local regulations. Only qualified personnel should perform installation, alignment and maintenance. The manufacturer reserves the right to alter the technical data in order to make improvements or update information. exclamat CAUTION! - Failure to observe these rules will render the guarantee invalid.
Introduction This booklet contains instructions for the use and maintenance of the D and D HF series water pumps, both single phase and three phase. The D and D HF electro pump has been designed to pump clean water not containing abrasive particles it can be used in wells with a minimum diameter of 125 mm (5”), as well as in containers or cisterns.
Check, in the case of a preinstalled control box and of a single phase pump that the value of the capacitor is according to the one stamped on the nameplate. In case of anomalies or any doubt please immediately contact your supplier or service point signaling the facts.
Maintenance and hydraulic inspection. Before proceeding with any kind of inspection or maintenance, make sure that the pump is disconnected • from the power fine without any chance of accidental reconnection. Normally the pump does not need any maintenance. It may happen that impellers get blocked by small •...
Need help?
Do you have a question about the flowpac compact 1F.BD and is the answer not in the manual?
Questions and answers