INFORMATION ABOUT REPLACEMENTS
6
6.3 Filter cartridge and fuel pre-filter replacement
NOTE : The fuel filter is situated on the crankcase of the engine or it
may be assembled on the frame of the vehicle.
Important
• Before proceeding with operation, read
Warning
• In case of low use replace il 12 months.
• For disposal of oil filter cartridge and fuel filter refer to
6.5 DISPOSAL and SCRAPPING
1. Disconnect the cable A of the water presence sensor C .
2. Remove the water presence sensor C from its cartridge B .
3. Loosen the cartridge B using the appropriate wrench.
4. Lubricate the gasket D of the new cartridge B.
Important
• Do not fill the new cartridge B with fuel.
5. Tighten the new cartridge B (Fig. 6.8) on the diesel fuel filter
support E using the special wrench (tightening torque of 17
Nm ).
6. Tighten the water presence sensor C on the new cartridge B
(tightening torque of 5 Nm ).
7. Reconnect the cable A of the water presence sensor C .
NOTE : Bleeding.
8. Push repeatedly the button G in order to fill the circuit.
NOTE: Click on the icon to play the procedure.
6.4 Air filter cartridge replacement
NOTE : Components not supplied by KOHLER .
Refer to the technical documentation of the vehicle..
6.5 DPF filter replacement
NOTE : Component to be replaced in the KOHLER authorised workshops.
1. A warning light will be activated to indicate that the DPF filter must be replaced.
NOTE : Refer to the machine manual.
2. New or regenerated DPF KITS are available
•
The regenerated KITS are certified and covered by a specific KOHLER warranty.
•
Cleaning processes that are not certified by KOHLER could cause irreversible damage to the DPF filter or
the ATS system.
EN
40
Par. 3.2.2
Par.
Fig 6.9
Fig 6.10
https://www.youtube.com/
embed/eHPkX9yprM4?rel=0?rel=0