Filter Cartridge And Fuel Pre-Filter Replacement; Air Filter Cartridge Replacement - Kohler KDI 3404 TCR Owner's Manual

5. Fit and tighten the cover A on the oil filter support F,
tightening it with a torque wrench G (tightening torque of
25 Nm).
6.3 Filter cartridge and fuel pre-filter check
NOTE: The fuel filter is situated on the
crankcase of the engine or it may be
assembled on the frame of the vehicle.
1. Disconnect the cable A of the water presence sensor C.
2. Remove the water presence sensor C from its cartridge B.
3. Loosen the cartridge B using the appropriate wrench
(Fig. 6.9).
4. Lubricate the gasket D of the new cartridge B.
• Do not fill the new cartridge B with fuel.
5. Tighten the new empty cartridge B (Fig. 6.9) on the diesel
fuel filter support E using the special wrench (tightening
torque of 17 Nm).
6. Tighten the water presence sensor C on the new cartridge
B (tightening torque of 5 Nm).
7. Reconnect the cable A of the water presence sensor C.
NOTE: Bleeding.
8. Push repeatedly the button G in order to fill the circuit.

6.4 Air filter cartridge replacement

NOTE: Component not supplied by KOHLER.
Refer to the technical documentation of the vehicle.
ED0053030050 _07
Index
INFORMATION ABOUT REPLACEMENTS
Important
F
6.7
G
B
A
6.8
E
D
B
6.9
6
A
C
B
B
C
EN
31