Table of Contents
Advertisement
6
6.3 Fuel filter and pre-filter cartridge replacement
NOTE:
The fuel filter is situated on the
crankcase of the engine or it may be
assembled on the frame of the vehicle.
1. Disconnect the cable A of the water presence sensor C.
2. Remove the water presence sensor C from its cartridge B.
3. Loosen the cartridge B using the appropriate wrench.
4. Lubricate the gasket D of the new cartridge B.
• Do not fill the new cartridge B with fuel.
5. Tighten the new empty cartridge B (Fig. 6.8) on the diesel
fuel filter support E using the special wrench (tightening
torque of 17 Nm).
6. Tighten the water presence sensor C on the new cartridge
B (tightening torque of 5 Nm).
7. Reconnect the cable A of the water presence sensor C.
NOTE:
Bleeding.
8. Push repeatedly the button G in order to fill the circuit.
6.4 Air filter cartridge replacement
NOTE:
Component not necessarily supplied by
KOHLER.
1. Pull insert F to unlock cover A.
2. Rotate counter clockwise and remove cover A.
3. Remove the cartridges B and G.
4. Fit cartridges G and B.
5. Fit cover A by performing the operations indicated in
points 2 and 1 in the reverse order.
EN
38
INFORMATION ABOUT REPLACEMENTS
Important
G
B
A
6.7
E
D
B
6.8
6.9
A
B
6.10
C
B
B
C
A
F
G
D
ED0053032140
_02
Index
Advertisement
Table of Contents
