INFORMATION ABOUT MAINTENANCE
5.8 Check Poly-V alternator belt
Important
•
Before proceeding with operation, read
Warning
•
For safety precautions see
NOTE : The poly-v belt is not adjustable.
1. Check the belt A condition, if worn out or deteriorated,
replace it.
NOTE : Make sure that the ribs of the belt A are inserted correctly
into the grooves of the pulleys B (as shown in D1 and D2 ).
2. Start the engine and run it for some minutes, then turn off it,
and let it cool down at ambient temperature.
Check by the appropriate tool that at point p the tension
value is between 135 and 178 Hz .
NOTE : If the poly-v belt tension results out of the above mentioned
values contact KOHLER authorised workshops for replacement.
5.9 Filter cartridge and fuel pre-filter check
Important
•
Before proceeding with operation, read
Warning
•
For safety precautions see
When turn on lights on control water filter cartridge fuel:
1. - Gently loosen the wing screw A without removing it.
2. - Drain the water if present.
3. - Re-tighten the wing screw A as soon as the fuel begins to flow.
Par. 3.2.2
.
Chap. 3
.
Par. 3.2.2
.
Chap. 3
.
Fig 5.14
Fig 5.15
Fig 5.16
5
35
EN