General Remarks - Kohler KDI 3404TCR Owner's Manual

3

3.2 General remarks

3.2.1 Note for OEM
• When installing the KDI engines, always bear in mind that any variation to the functional systems may result
in serious failures to the engine.
• Any improvement must be verified at KOHLER testing laboratories before application of the engine.
•
In case the approval to a modification is not granted, KOHLER shall not be deemed responsible for any
consequential failures or damages to the engine.
•
Those who carry out the use and maintenance on the engine must wear the safety equipment and the
accident-prevention guards.
• KOHLER declines all direct and indirect liability for failure to comply with the standards of conduct contained
in this manual.
• KOHLER cannot consider every reasonably unforeseeable misuse that may cause a potential danger.
3.2.2 Note for end user
• The following indications are dedicated to the user of the machine in order to reduce or eliminate risks
concerning engine operation and the relative routine maintenance work.
• The user must read these instructions carefully. Failure to do this could lead to serious danger for his
personal safety and health and that of any persons who may be in the vicinity of the machine.
• On starting, make sure that the engine is as horizontal as possible, unless the machine specifications differ.
•
Make sure that the machine is stable to prevent the risk of overturning.
• The engine must not operate in places containing inflammable materials, in explosive atmospheres, where
there is dust that can easily catch fire unless specific, adequate and clearly indicated precautions have been
taken and have been certified for the machine.
•
To prevent fire hazards, always keep the machine at least one meter from buildings or from other machinery.
• Children and animals must be kept at a due distance from operating machines in order to prevent hazards
deriving from their operation.
•
Thoroughly wash and clean all the external parts of the engine before performing any operation, in order to
avoid the accidental introduction of impurities/foreign bodies. Use only water and/or appropriate products to
clean the engine. If cleaning engine with a pressure washer or steam cleaner, it is important to maintain a
minimum distance of at least 200mm between the surface to be washed and the nozzle. Avoid directing the
nozzle on electrical components, cable connections and sealed rings (oil seals etc). Thoroughly wash and
clean the area surrounding the engine following the instructions provided by machine manufacturer.
•
Fuel and oil are inflammable. The tank must only be filled when the engine is off. Before starting, dry any spilt
fuel.
• Make sure that no soundproofing panels and the ground or floor on which the machine is standing have not
soaked up any fuel.
• Fuel vapour is highly toxic. Only refuel outdoors or in a well ventilated place
•
Do not smoke or use open flames when refuelling.
• During operation, the surface of the engine can become dangerously hot. Avoid touching the exhaust system
in particular.
• Before proceeding with any operation on the engine, stop it and allow it to cool.
•
Always open the radiator plug or expansion chamber with the utmost caution, wearing protective garments
and goggles.
•
The coolant fluid is under pressure. Never carry out any inspections until the engine has cooled.
• If there is an electric fan, do not approach the engine when it is still hot as the fan could also start operating
when the engine is at a standstill.
• The oil must be drained whilst the engine is hot. Particular care is required to prevent burns. Do not allow oil
to come into contact with the skin because of the health hazards involved. It is recommended to use an oil
intake pump.
•
During operations that involve access to moving parts of the engine and/or removal of rotating guards,
disconnect and insulate the negative wire (-) of the battery to prevent accidental short-circuits and to stop
the starter motor from being energized.
• Check belt tension only when the engine is off.
• Fully tighten the tank cap each time after refuelling. Do not fill the tank right to the top but leave an adequate
space for the fuel to expand.
EN 20
SAFETY INFORMATION